The correct installation of the Gear Reducer
Correct installation, use and maintenance of reducer, is to ensure the normal operation of mechanical equipment important link. Therefore, when you install the NEUGART planetary reducer, be sure to carefully use and use the following items in accordance with the following installation.
The first step is to confirm the motor and reducer before installation is intact, and strictly check the motor and reducer connected to the size of the various parts of the match, here is the motor positioning boss, input shaft and reducer groove size and cooperation tolerance.
The second step is to unscrew the screws on the outside of the flange of the reducer flange, adjust the PCS system clamping ring so that its side hole aligned with the dust hole, insert the hexagonal tightening. After that, take the motor shaft key.
The third step is to connect the motor to the Gear Reducer naturally. The connection must ensure that the output shaft of the reducer and the motor input shaft concentricity, and the two outside the flange parallel. If the degree of inconsistency, will lead to motor shaft broken or reducer gear wear.
In addition, the installation, it is strictly prohibited with hammer and other hitting, to prevent axial or radial force is too large damage to the bearing or gear. Be sure to tighten the mounting bolts and tighten the tightening bolts. Before installation, the motor input shaft, positioning boss and reducer connection parts of the anti-rust oil with gasoline or zinc sodium water wipe net. Its purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear and tear. Before connecting the motor to the Gear Reducer, first connect the motor shaft keyway to the tightening bolts. To ensure uniform force, please put any diagonal position of the installation bolts spin, but do not tighten, and then spin the other two diagonal position of the installation bolts and finally one by one tighten the four mounting bolts. Finally, tighten the tightening bolts. All tightening bolts shall be fixed and inspected with the torque wrench according to the indicated fixed torque data. Right angle reducer of the relevant data and the same type of linear reducer is not exactly the same, please also pay attention to the user. * The correct installation between the reducer and the mechanical equipment is similar to that between the Gear Reducer and the drive motor. The key is to ensure that the reducer output shaft and the drive part of the axis of concentricity consistent.
Fourth, the conclusion With the continuous development of global industry, planetary reducer in the field of transmission in the role of more and more obvious. Hope in the future use of the process, planetary reducer can bring you more convenience and benefits!